Engine Tools

Designed to lock the camshafts and crankshaft sprockets when removing, replacing and torquing the sprocket bolts Made of non-marring Delrin® Instructions included Made in the U.S.A.

Make your life easier with the Motion Pro Deluxe Piston Pin Tool. Interchangeable piston adapters Made of durable 6061 aluminum Fits all piston pins from 13mm (.511") to 24mm (1") Works on both full skirt and short skirt (slipper)...

Main Seal Remove/Installer from Jims for the Harley Twin Cam. Fits: 1999-2016 Harley Twin Cam Remove and install crankcase main seal while engine is still in chassis Hardened steel construction Includes necessary adapters for 88 and 96 Twin...

Left Main Seal Remover from Jims for the Harley M8. Fits: 2017-2019 M8 Engines Remove crankshaft oil seal without damaging crankcase bore Made in the U.S.A.

Cylinder Torque PLates from Jims for the Harley M8. Fits: 2017-2019 M8 Engines Torque plates must be used when boring or honing late-model aluminum cylinders Simulates running stress conditions Instructions included Made in the U.S.A.

JIMS Wrist Pin Remover adapter for the M8. Fits: M8 Engines Quickly and easily removes wrist pins from Milwaukee Eight™ engines Used with existing wrist pin tool PART #1276 (sold separately) Made in the U.S.A.

Valve Spring Colllar for the M8. Fits: M8 Engines For use with JIMS existing valve spring compressor PART #96600-36B (sold separately) Valve spring collar allows existing compressor to remove smaller valves on Milwaukee Eight™ engines Made in...

Keep the cylinders in place when pulling the heads. Fits: M8 and 99-17 Twin Cam Engines Helps to keep the cylinders in place when removing the heads from the engine One end fits Twin Cam® models and the other fits Milwaukee Eight™...

Easily and safely remove need bearing from the M8. Fits: M8 Engines Correctly and accurately replace the camshaft inner needle bearing in Milwaukee Eight™ engines Uses the proven JIMS® syle remover collet and fine threaded installation...

Use whenever tappet blocks are removed, or even just loosened Tappet blocks do not have counter-bored bolt holes; therefore, they should be reinstalled using an alignment tool to ensure that the lifters track properly on the camshaft This tool...